Skip to main content
The Method of IP Configuration

Help users to configure the computer IP

W
Written by Wang Daniel
Updated over 3 years ago

●   If you have not changed the IP address of the control box, please use the computer to directly connect the UFACTORY xArm to check whether the computer IP is in the       192.168.1  network segment and does not conflict with the IP address of the control box. You must confirm that the IPV4 network segment of your computer should be     192.168.1.1-192.168. 1.255 (The tail number should be 1 to 255 and cannot be the same as the IP address of the control box). 

●   If you have changed the IP address of the control box, please connect the UFACTORY xArm directly with the computer to check whether the computer IP is on the same network segment as the control box and does not conflict with the IP address of the control box.

●   IP Setting

     Network and Sharing Center → Ethernet → Properties → IPV4

     Step1: Open the “Network and Sharing Center”

Step2: Open the “Ethernet”

Step3: Open the “Properties”

Step4: Open the “IPV4”

Step5: 

Then check whether the computer IP is within 192.168.1.1-192.168.1.255 (the tail number should be 1 to 255, and can not be the same as the IP address of the control box). If not, please modify the computer's IP.

Step6: 

After the modification is completed, please verify the IP address of the computer: enter cmd in the search box (see the figure below), open a command prompt, and directly ping the IP address of the UFACTORY xArm in the doc command line: ping 192.168.1.XXX (see the figure below ). You can successfully send and receive data packets.

Did this answer your question?